Shark NV350Q manual Cleaning the Turbo Brush, Cleaning the Motorized Floor Brush

a

Fig. 29

Rotating

Brush

Fig. 31

Fig. 30

CLEANING THE TURBO BRUSH

1Slide the locking latch (a) forward and gently tilt brush housing upward to open. (Fig. 29)

IMPORTANT: DO NOT force; it will not open all the way.

2Carefully remove any blockage or debris.

3Turn the turbo brush over to inspect the rotating brush and cut away any build-up of hair or string wrapped around the rotating bristle brush with scissors. (Fig. 30)

4Push the housing back down and slide the locking latch backward to lock.

CLEANING THE MOTORIZED FLOOR BRUSH

When your motorized floor brush needs cleaning or locks onto an object, it automatically shuts down to prevent damage to your lifetime belt. The indicator light will illuminate red warning you to turn off the vacuum and clear blockage immediately. The light will reset itself once blockage has been cleared and power has been cycled on/off or vacuum has been locked in the upright position.

1Detach the motorized floor brush from the detachable canister.

2Inspect the opening underneath and the rotating brush. If a build-up of debris is present, remove it. Carefully cut anything wound around the rotating brush with scissors. Avoid damaging or cutting the bristles. (Fig. 31)

15

NV350Q_26_IB_ENG_101019.indd 15 10-10-19 9:19 AM