Threading the machine, Threading main unit using side

Threadingthemachine

1.Raise thread spindle (C) by grasping the exposed top and pulling upward until thread spindle (C) is fully extended.

2.Place thread spool (E) on the

	thread spindle (C) as shown.	2
3.	Pull thread from the thread	2
	spool (E) on the thread spin-	1
	dle (C) and put it through the
	thread holder (1) in the direc-
	tion toward front of machine.	3
4.	Bring thread across to the	3
	thread tension screw (2).	4
	Thread goes over the tension
	adjusting screw and must be
	positioned between the two
	washers behind the tension	5
	adjusting screw(Q). This is	5
	adjusting screw(Q). This is
	what provides the lockstitch
	tension to the thread.
5. Pull thread from tension		6
	adjusting screw (Q) guide	6

through thread take up lever

(D) in the direction toward front of machine (3).

6. Pull thread through thread guide (4) inserting in the direction toward the front of the machine.

7. Pull thread down to thread

	guide (5) and insert thread
	from the top downward. If
	necessary, lower the needle
	(R) to reach this guide by
	turning the hand wheel (K)	Threading main unit using side
	slightly counter-clockwise (in the direction
		bobbin
	toward you) to lower the needle (R).
	8. Raise the needle (R) to reach the eye by	(Follow steps 4-10 with these exceptions.)
	turning the hand wheel (K) slightly	1. Pull bobbin spindle (U) out from main unit.
	clockwise (in the direction away from you).
		2. Insert bobbin spindle (U) through center
	Insert thread through eye (6) of the needle
		hole of threaded bobbin.
	from the front toward the back of the
		3. Insert bobbin spindle (U) (with bobbin
	machine (use threader accessory if
		attached) into bobbin holder (V). Make
	necessary).
		sure bobbin spindle (U) with bobbin are
	9. Raise the Presser Foot (F) by lifting up on
		tightly secured to main unit.
	the lever at the rear of machine (G).
		Note: thread main unit with side bobbin
	10.Pull about 10 inches of thread through the
		simultaneously with thread spool for a double
	needle (R) and lay it on the deck under the
		stitch method. Side bobbin is to be used only
	presser foot (F) running in the direction
		if you’re using this particular method of
	away from you.
		stitching.