Sears 385.12514 Choose the Needle and Thread, To Change the Needle, Set Up the Machine, Extension

SECTION 2. PREPARE THE MACHINE FOR SEWING

Set Up the Machine (Continued)				Choose the Needle and Thread
• Free-Arm	Sewing: the Removable	• Accessory Storage Box	• Change the Presser Foot	• To Change the Needle
Extension	Table
f-		r

G

i t

Needte clamp screw

Fla! l[

s_e [l

away II _rom 1t

J

To Remove the Extension Table (for free-arm sewing)

1.Grip the table with your index finger and thumb, as shown.

2.Pull gently to the left. The extension table will snap out.

To Attach the Extension Table (for flat-bed sewing)

1.Insert the tab and the pin into their catches.

2.With your thumb and index finger, gently snap in.

J

The lld ot the accessory storage box lifts open toward you.

Sewing accessories are conveni- ently located in the box.

J

Use the correct presser toot for the stitch you wish to sew,

To change the various presser foot, raise the presser bar to its highest position by lifting the presser foot lever.

Loosen the presser foot thumb screw, choose the proper foot, insert from the bottom.

Tighten the screw using the large screw driver to make certain the loot is secure.

You _.

J

NOTE: Raise the needle bar to its highest position by turning the hand wheel toward you.

Loosen the needle clamp screw by turning it toward you.

2. Remove the needle by pulling it downward.

3.Insert the new needle into the needle clamp with the flat side away from you.

4.Push the needle up as far as it will go.

5.Tighten the needle clamp screw firmly

with the large screwdriver trom the accessory box.