Euro-Pro 1104HG, 1104HV, 1104HW, 1104HB Stitch Length Adjustment & Reverse Sewing, Work Light

SEWING

Fig. 1

Fig. 2

Fig. 3

1.Turn the hand wheel to raise up the needle to the highest position. Lift the presser foot and place the fabric to be sewn under the presser foot. (Fig. 1)

2.Lower the presser foot. (Fig. 2)

3.Press the On/Off button to the “On” position and begin sewing. Do not pull the fabric. Gently guide the fabric to keep the seam straight. (Fig. 3)

4.After finishing sewing, press the On/Off button to the “Off” position to stop sewing. (Fig. 3)

5.Turn the hand wheel to raise the needle to the highest position. Lift the presser foot and gently remove the fabric away from the sewing machine. (Fig. 4)

6.Cut the thread using the thread cutter. (Fig. 5)

Fig. 4

Fig. 5

STITCH LENGTH ADJUSTMENT & REVERSE SEWING

0 0

Regular Sewing Reverse Sewing

Before sewing your garment, test for the correct stitch length using a piece of fabric. You can select from three different (3) stitch lengths for sewing and three (3) for reverse sewing. To select the stitch length:

1.Turn the stitch length adjustment dial all the way to the left for the longest stitch length. This is recommended for normal sewing.

2.As you turn the dial to the right, you decrease the length of the stitch until you get to the center point which is “0” length. The needle will remain stationary if you set the dial at this point.

3.As you continue to turn the dial to the right, you will now set the sewing machine into reverse sewing. Again, you have three (3) different stitch lengths for reverse sewing, the farthest to the right being the longest.

4.Use reverse sewing to secure your stitches at the beginning of your seam and at the end. This will strengthen your seams.

Caution: Do not sew at “0” stitch length as this will cause your machine to get stuck.

WORK LIGHT

If additional light is needed, press the light switch to turn the light “On”. Press the switch again to turn it “Off”.

5 6