Ceatin9
the
1’Vee?te
‘heae
Before you begin make sure that the needle is at its highest position, i.e. that the lower hole of the
ascending
With your left hand push needle threader control down until threader prong w (see opposite
page) penetrates needle eye. Keep control in this position.
Hold thread loosely and lead it from left around the small pin, then place it behind hook of
threader prong.
Release control slightly until prong w reverses and pulls thread through needle eye.
Jerk control down again so the thread loop will fall off the prong. Pull thread through needle
eye and release control.
R8008 | I | R8013 | 2 | R8009 | 3 | R8010 | 4 |