5 DOOR REPLACEMENT IN SIDING
WITHOUT NAIL FIN (continued):
Frame Screw Method:
Note: If installing with installation clips, proceed to step P.
J.Jambs: Drill and counter sink 3/16" diameter clearance holes through the door frame only and not into the rough opening at the locations shown on the diagrams.
Note:
5J |
K.Frame Head: Drill and counter sink 3/16" diameter clearance holes through the door frame head only and not into the rough opening at the locations shown on the diagrams.
L.Threshold: Drill and counter sink 3/16" diameter clearance holes through the threshold but not into the rough opening at the locations shown on the diagrams
M.Drill 1/8" x 1" deep pilot holes through the clearance holes and into the rough opening framing in the head, jambs and threshold of the unit frame.
N.Secure the jambs and head of the door. Drive #10 x
O.Secure the sill by driving #10 x
Go back to 3H - 3P to complete fastening through hinges and strikes.
Installation Clip Method:
See Step 2C for Clip Application Details
P.Fasten the door to the opening by driving
two #8 x
interior stud/block, install the screws as 5PF close to the bend as possible.
Note: DO NOT shim above the door. For masonry openings use two masonry screws that are a minimum size of 3/16" x
Go back to 3H - 3P to complete fastening through hinges and strikes.