3 SETTING AND FASTENING THE DOOR (continued):
K.Double Doors Only:
Designer Series®: Place a dab of sealant into the center sill strike hole and install the
#8 x 3" flat head corrosion resistant screw (provided) or a 3/16" masonry screw into the hole.
ProLine®: Remove the screw from the sill strike located on the door sill, then place a dab of sealant into the sill strike hole and install the #8 x 3" flat head corrosion resistant screw (provided) or a 3/16" masonry screw into the hole.
Entry Doors: Remove the two screws from the sill strike located on the door sill. Place a dab of sealant into the center sill strike hole and install the #12 x
L.Double Doors Only: Shim between the frame and the rough opening at the head strike location and at every frame anchor hole location. Keep shims back 1/2" from
interior face of the door frame.
Designer Series: Install the #8 x 3" flat head corrosion resistant screws (provided) into the hole.
ProLine: Remove the screw from the head strike located on the door head then install the #8 x 3" flat head corrosion resistant screws (provided) into the hole.
Entry Doors: Remove the two screws from the head strike located on the door head. Install the #12 x
Note: For doors with
M.On each hinge, starting at the top drill an 1/8" pilot hole insert a corrosion resistant screw (#8 X 3” provided) into the open screw hole. Make sure the screw passes through the shims and into the structural framing.
3L
3K
3M3L
N. Check door operation. Open and close the door to |
| |
check for proper operation. Make sure the door will |
| |
latch correctly. |
| |
Note: If there are any problems with the operation, |
| |
check to confirm the door frame is installed plumb, level |
| |
and square. If the reveal between the door panel(s) and |
| |
frame is not even, adjustments may be made: |
| |
Doors without adjustable hinges: Plastic shims located |
| |
behind the hinges may be removed to adjust the reveal | Adjustable | |
between the door panel and door frame. Additional | ||
Hinge | ||
hinge shims may be added if required. | ||
|
Hinge
Note: Doors with adjustable hinges will have a
Adjustable hinges are not designed to make up for incorrect installation of a door frame. Before adjusting hinges, confirm the door is installed plumb, level and square.
O.For Doors with adjustable hinges: The hinges can be used to move the panel side to side by moving all hinges in the same direction or the hinges can slightly rotate the panel by adjusting the hinges in opposite directions. Use a T20 Torx wrench for Entry Doors or a 1/8" Allen wrench for Designer Series doors to turn the center screw clockwise (+) to increase the space between the hinge side of the frame and door panel. Turn the center screws