Add local port…

“Add local port…" to enter the printer name and printer port in the dialog box.

Add network printer…:

Click (shared) printers and double-click one of the listed printers. Enter the printer name and the printer's network path. A new network printer is installed by double clicking the NET0 printer icon.

Advanced settings contain Bandwidth, Port number and Device Write Timeout in sec.

Figure 25: ThinPrint Client CE - Advanced

Bandwidth:

Enter a bandwidth value which is the same or smaller than that set in .print Engine. If the value is larger or if Client Control is disabled at the server, server settings are applied.

Enter 0 to retain server settings.

Port number:

Enter the port number where .print Client should receive incoming connections. Be sure that the TCP/IP port number is the same on both .print Client and server-side .print Engine. Otherwise, communication between the two .print components is impossible.

Note: TCP/IP Port number is of course only relevant for printing over TCP/IP. The default port number is 4000.

Quit Client:

Click "Quit Client" to exit .print Client. (.print Client must be restarted before ThinPrint .print printing resumes).

Click OK for all changes to apply without quitting .print Client. Some changes are only effective after having restarted .print Client.

Click ⌧ button to quit the dialog box without saving changes.

User's Guide for A2xx with WinCe

Build # 5