Pella 802Q0102 Applying Installation Fins, To Install the Windows Proceed to C

Page 6

APPLYING INSTALLATION FINS

$ 6OLGHWKHSUHFXWERWWRPŵQLQWRWKH	Frame head groove
$ 6OLGHWKHSUHFXWERWWRPŵQLQWRWKH
frame sill groove located on the
bottom window frame member.

% ,QVWDOOWKHSUHFXWVLGHŵQV into the top of the frame jamb grooves located on the side frame members of the window. Slide the ŵQVLQWRSODFH

Note: The side ﬁns must overlap the exterior of the bottom ﬁn.

Frame

C. Install and slide the precut top sill groove ŵQLQWRWKHIUDPHKHDGJURRYH

located in the top frame member.

	Note: The top ﬁn must overlap	A
	the exterior of the side ﬁns.	A
	the exterior of the side ﬁns.
		Frame jamb groove
	' 6HDOWKHRYHUODSSLQJŵQMRLQWVZLWKVHDODQW

Image 6

Contents Equivalent high quality, multi-purpose sealant JDOYDQLHGURRŵQJQDLOVOEDoor ﬂashing tape or equivalent Window and door foam sealant do not use highCut the water resistive barrier Rough Opening PreparationConﬁrm the window will ﬁt the opening. Measure all Apply sill ﬂashing tape #2. Cut a piece of ﬂashing tapeTWO or More People will be Required for the Following Steps Setting and Fastening the WindowRemove plastic wrap and cardboard packaging from Check the window operation.5HPRYHWKHSODVWLFApply side ﬂashing tape. Cut two pieces of ﬂashing Integrating the Window to the Water Resistive BarrierInterior Seal Apply flashing tape to diagonal cuts. Cut piecesShape, tool and clean excess sealant. When Sealing the Window to the Exterior Wall Cladding5A$ Applying Installation Fins To Install the Windows Proceed to CFrame sill groove located on Bottom window frame member Care and Maintenance Important Notice Finish