Desa SL30NT/SL30PT installation manual Top

Page 16

16

TROUBLESHOOTING

TROUBLESHOOTING

Continued

WARNING: If you smell gas

•Shut off gas supply.

•Do not try to light any appliance.

•Do not touch any electrical switch; do not use any phone in your building.

•Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s instructions.

•If you cannot reach your gas supplier, call the fire department.

IMPORTANT: Operating heater where impurities in air exist may create odors. Cleaning supplies, paint, paint remover, cigarette smoke, cements and glues, new carpet or textiles, etc., create fumes. These fumes may mix with combustion air and create odors. These odors will disappear over time.

OBSERVED PROBLEM

POSSIBLE CAUSE

REMEDY

Heater produces a clicking/ticking noise just after burner is lit or shut off

1.Metal expanding while heating or con- tracting while cooling

1.This is common with most heaters. If noise is excessive, contact qualified ser- vice person

Heater produces unwanted odors	1.	Heater burning vapors from paint, hair
		spray, glues, cleaners, chemicals, new
		carpet, etc. (See IMPORTANT state-
		ment above)
	2.	Gas leak. See Warning statement at
		top of page

1.Open window and ventilate room. Stop using odor causing products while heater is running

2.Locate and correct all leaks (see Check- ing Gas Connections, pages 9 and 10)

Heater shuts off in use (ODS operates)	1.	Not enough fresh air is available
	2.	Low line pressure
	3.	ODS/pilot is partially clogged

1.Open window and/or door for ventilation

2.Contact local natural or propane/LP gas company

3.Clean ODS/pilot (see Cleaning and Maintenance, page 13)

Gas odor even when control knob is in OFF position

1.Gas leak. See Warning statement at top of page

2.Control valve defective

1.Locate and correct all leaks (see Check- ing Gas Connections, pages 9 and 10)

2.Replace control valve

Gas odor during combustion	1.	Foreign matter between control valve
		and burner
	2.	Gas leak. See Warning statement at
		top of page

1.Take apart gas tubing and remove for- eign matter

2.Locate and correct all leaks (see Check- ing Gas Connections, pages 9 and 10)

For..com

111487-01B

Image 16

Contents Csbnt Csbpt Cspbnt Cspbpt Cspint Cspipt What to do if YOU Smell GASTable of Contents Safety InformationProduct Identification Typical Stove Cabinet Model with Comfort Glow Gas Log HeaterLocal Codes Product FeaturesAIR for Combustion and Ventilation Determining FRESH-AIR Flow for Heater Location Determining if You Have a Confined or Unconfined SpaceVentilation AIR Ventilation Air From Inside BuildingInstallation UnpackingVentilation Air From Outdoors Stove TOPClearances to Combustibles Vent-Free Operation Only Check GAS TypeMinimum Wall and Ceiling Clearances see Figure Connecting to GAS Supply Installation Items NeededPressure Testing Gas Supply Piping System Checking GAS ConnectionsInstalling ROD and Screen Pressure Testing Heater Gas ConnectionsInstalling LOG SET For Your Safety Read Before LightingOperating Heater Lighting InstructionsManual Lighting Procedure Inspecting BurnersThermostat Control Operation To Turn OFF GAS To ApplianceCleaning Maintenance Cleaning Burner Injector Holder and Pilot AIR Inlet HoleMain Burner LogsTroubleshooting Observed Problem Possible CauseObserved Problem Possible Cause Remedy Maintenance,Top Specifications Service HintsTechnical Service AccessoriesIllustrated Parts Breakdown Models SL30PT and SL30NTParts List KEY Part Number SL30PT SL30NT Description QTYStove Body Models CSB SERIES, Cspb Series Cspi Series KEY Part Number Description QTY Parts Centrals FBDOwners Registration Form Postage Required 111487-01B Warranty Information