Introduction
This manual deals specifically with the Installation, Safety, Maintenance, Installer De- tails, Service and Warranty aspects of your new Defy Stove. It should be read in con- junction with the separate instruction handbook supplied.
Unpacking
•Please ensure that packaging material is disposed of in a responsible manner.
•Plastic bags should be cut up to prevent children playing with them and acciden- tally suffocating.
•If the appliance is damaged in any way, do not use it. Report the damage to your dealer, who will take the necessary corrective action.
Instructions for the installer
Electrical installation
•Insert the fitted 15A.
•This appliance must be earthed. The manufacturer and the seller do not accept re- sponsibility for any damage due to incorrect installation or electrical connection.
LPG (Liquid Petroleum Gas) Installation
•The installation must conform with the requirements of SANS 10087-1.
•Soak the end of the plastic hose in hot water to soften it and then push the hose end fully over the hose nozzle. (See sketch 1 below)
•Secure the hose by tightening the hose clamp. ( See sketch 2 below)
•Similarly, secure the other end of the hose to the regulator on the gas bottle.
O Seal
REGULATOR 
|
| Clamp | |
1 | 2 | ||
| |||
|
|
Caution: Never use a naked flame to check for gas leaks
•Check for gas leaks after installation and whenever a new or
•Ensure that the control knobs on the hob are in the OFF position.
•Open the valve on the Gas bottle.
•Using a small paint brush, apply some soapy water to all the connections.
•If there is a leak, bubbles will appear.
•If this happens, close the valve on the gas bottle.
•Check and tighten the connections immediately.
•Repeat the procedure to ensure that there are no further leaks.
Page 2