Drolet WOODSTOVES owner manual Floor Protector

Page 11

FLOOR PROTECTOR

Your wood stove should be placed on a non-combustible surface. The floor protector should be under the stove, eighteen inches beyond the front and eight inches beyond each side of the fuel loading and ash removal opening. If there is a horizontal section of chimney connector, the floor protector should go under it and two inches beyond each side.

The floor protector should exceed the stove as follows:

FRONT SIDES BACK

18’’ 8’’ 8’’ (460 mm) (200 mm) (200 mm)

Image 11

Contents Read and Keep this Manual for Reference Table of Contents Introduction Dimensions Overall Technical SpecificationsTips on Wood Heating Pedestal and Panels AssemblyLegs and ASH PAN Ash Lip InstallationDoor Adjustment Door AdjustmentBenefits of Installing a Blower Positioning the Stove InstallationFloor Protector Single pipe / Double pipe Clearances from CombustiblesType of Protection Reduced ClearancesChimney Chimney Connector Stove Pipe Factory Built Chimney Typical InstallationsLay liner Thimb le Clean out Door Factory Built Thimble Brick Thimble Outside Combustion AIR Average Enrgy Yield of ONE AIR Dried Cord of CUT Wood Woodstove UtilisationIgnition Testing Your WoodFirst Fires Heating Creosote Formation and Need for Removal ReloadingASH Disposal Paint MaintenanceGlass GasketingDrolet Limited Lifetime Warranty