Drolet WOODSTOVES owner manual Assembly, Pedestal and Panels

Page 6

ASSEMBLY

PEDESTAL AND PANELS

Pedestal Base Installation:

1. Slide the front part of the pedestal base around the pedestal and fix the rear part with the two supplied screws.

2. Slide the ash pan in position.

Side Panels and Ash Lip

Installation:

1. Start by fixing the front part of the decorative side in the two clips welded on the sides of the fire box.

2. Then, fix the back of the decorative side with two screws and washers

supplied. Line up the decorative side parallel to the side of the appliance.

3. Clip the ash lip into position, centred just below the door.

5

Image 6

Contents Read and Keep this Manual for Reference Table of Contents Introduction Technical Specifications Dimensions OverallTips on Wood Heating Assembly Pedestal and PanelsAsh Lip Installation Legs and ASH PANDoor Adjustment Door AdjustmentBenefits of Installing a Blower Installation Positioning the StoveFloor Protector Clearances from Combustibles Single pipe / Double pipeReduced Clearances Type of ProtectionChimney Chimney Connector Stove Pipe Typical Installations Factory Built ChimneyLay liner Thimb le Clean out Door Factory Built Thimble Brick Thimble Outside Combustion AIR Woodstove Utilisation Average Enrgy Yield of ONE AIR Dried Cord of CUT WoodTesting Your Wood First FiresIgnition Heating Reloading Creosote Formation and Need for RemovalASH Disposal Gasketing MaintenanceGlass PaintDrolet Limited Lifetime Warranty