Drolet WOODSTOVES owner manual Benefits of Installing a Blower

Page 9

THE BENEFITS OF INSTALLING A BLOWER

A blower can be installed at the back of your DROLET stove. This option is necessary if you wish to redistribute into a room the heat trapped at the back of your stove. By forcing hot air toward the front, the blower enables you to extend the radiation power of your stove.

You can purchase this option through your DROLET dealer. Make sure to specify this part number: #AC02050. You can also install a thermodisc to enable the blower to start or stop automatically when the stove is hot or too cold. The thermodisc part number is AC05530. Installation instructions are supplied with the blower and the thermodisc.

8

Image 9

Contents Read and Keep this Manual for Reference Table of Contents Introduction Dimensions Overall Technical SpecificationsTips on Wood Heating Pedestal and Panels AssemblyLegs and ASH PAN Ash Lip InstallationDoor Adjustment Door AdjustmentBenefits of Installing a Blower Positioning the Stove InstallationFloor Protector Single pipe / Double pipe Clearances from CombustiblesType of Protection Reduced ClearancesChimney Chimney Connector Stove Pipe Factory Built Chimney Typical InstallationsLay liner Thimb le Clean out Door Factory Built Thimble Brick Thimble Outside Combustion AIR Average Enrgy Yield of ONE AIR Dried Cord of CUT Wood Woodstove UtilisationTesting Your Wood First FiresIgnition Heating Creosote Formation and Need for Removal ReloadingASH Disposal Glass MaintenanceGasketing PaintDrolet Limited Lifetime Warranty