Drolet HT1600, HT1200, HT2000 owner manual Maintenance, Glass, Gasketing, Paint

Page 27

MAINTENANCE

Your Drolet stove is a high efficiency stove and therefore require little maintenance. It is important to perform a visual inspection of the stove every time it is emptied, in order to insure that no parts have been damaged, in which case repairs must be performed immediately.

GLASS

Inspect the glass regularly in order to detect any cracks. If you spot one, turn the stove off immediately. Do not abuse the glass door by striking or slamming shut. Do not use the stove if the glass is broken.

If the glass on your stove breaks, replace only with glazing supplied from the Drolet dealer.

To replace the glass, remove the screws retaining the glass mouldings inside the door. Remove the mouldings and replace the damaged piece with a new one. Perform the procedure backwards after replacing. When replacing the glass, you should change the glass gasket to make sure you keep it sealed.

Never wash the glass with a product that may scratch. Use a specialized product, available in the stores where wood stoves are sold.

The glass should be washed only when cold.

GASKETING

It is recommended that you change the door gasket (which makes your stove door air tight) once a year, in order to insure good control over the combustion, maximum efficiency and security. To change the door gasket, simply remove the damaged one. Carefully clean the available gasket groove, apply a high temperature silicone sold for this purpose, and install the new gasket. You may light up your stove again approximately 24 hours after having completed this operation.

WARNING:

NEVER OPERATE THE STOVE WITHOUT A GASKET OR WITH A BROKEN ONE. DAMAGE TO THE STOVE OR EVEN HOUSE FIRE MAY RESULT

PAINT

Only clean your stove with a dry soft cloth that will not harm the paint finish.

If the paint becomes scratched or damaged, it is possible to give your wood stove a brand new look, by repainting it with a 1200o F heat resistant paint. For this purpose, simply scrub the surface to be repainted with fine sand paper, clean it properly, and apply thin coats (2) of paint successively. Refer to page 18 of the present manual for the paint curing process.

26

Image 27 Contents
Read and Keep this Manual for Reference OWNER`S Manual Drolet EPA WoodstovesTable of Contents Introduction HT-1200 HT-1600 HT-2000 Technical SpecificationsPedestal and Decorative Sidewall Installation AssemblyHT-1200 & HT-1200 Deluxe Bricks Bricks Installation HT-1200HT-1600 Refractory Bricks Assembly Bricks and Insulation Installation HT-1600HT-2000 Refractory Bricks Assembly Brick and Insulation Installation HT-2000Air Tubes Installation AIR Tubes Installation HT-2000Door Adjustment Door AdjustmentBenefits of Installing a Blower Positioning the Stove InstallationFloor Protector Canada ClearancesType of Protection Reduced ClearancesChimney Chimney Connector Stove Pipe Factory Built Chimney Typical InstallationsClay liner Thimble Clean out Door Factory Built Thimble Brick Thimble Average Energy Yield Of One Air Dried Cord Of Cut Wood Woodstove Utilization Testing Your Wood First Fires Ignition HT-2000 Deluxe HeatingCreosote Formation and Need for Removal ReloadingASH Disposal Paint MaintenanceGlass GasketingDescription Warranty Application Limited Lifetime Warranty