![](/images/new-backgrounds/1027930/279309x1.webp)
Operating Instructions
CHIMNEY OR RUN AWAY FIRE:
1.Call local fire department (or dial 911)
2.Close the draft fully
3.Examine flue pipes, chimney, attic, and roof of the house, to see if any part has become hot enough to catch fire. If necessary spray with fire extinguisher or water from the garden hose.
4.Do not operate the stove again until you are certain the chimney and its lining have not been damaged.
MAINTENANCE:
At the end of each heating season clean the chimney and the smoke pipe. If soot has accumulated above the top baffle bricks, remove, clean, and then replace them. If the secondary air tube is badly eroded, replace it. Replace worn door gaskets and broken bricks as needed.
FAILURE TO INSPECT AND CLEAN YOUR CHIMNEY SYSTEM REGULARLY CAN RESULT IN A CHIMNEY FIRE, WHICH COULD DAMAGE THE CHIMNEY OR CAUSE A HOUSE FIRE.
BUILDING YOUR FIRE:
Proper operation of your stove will help to ensure safe, efficient heating. Please take a few moments to review these simple operating procedures.
1. Fuel Selection:
This stove is designed to burn natural wood only. Higher efficiencies and lower emissions generally result when burning
2. Building/Maintaining a Fire:
a)Open the primary air slide by pulling it all the way to the right.
b)Place a base of crumpled uncolored newspaper in the bottom of the stove. Lay pieces of kindling on top of the newspaper and light it.
CAUTION: “Never use gasoline,
c)As the kindling begins to burn, add several larger pieces of wood until the fire is burning well. At this point, regular size logs may be added.
NOTE: Until the fire is burning well, leave the draft controls fully open.
d)Regulate the heat output of the stove by adjusting the draft controls to allow a larger fire and vice versa. A short period of experimentation with the control settings will allow you to regulate the heat output to keep your home comfortable.
Do not use a grate or elevate the fire. Build wood fire on the stove firebox hearth floor.
5