Enviro 50-1573 Safety Warnings & Recommendations, USE of Cordwood is Prohibited by LAW

Page 4

Safety Warnings & Recommendations

Please read this entire Owner’s Manual before installing or operating your ENVIRO Pellet Stove. Failure to follow these instructions may result in property damage, bodily injury or even death. Any unauthorized modification of the appliance or use of replacement parts not recommended by the manufacturer is prohibited. All national and local regulations and European Standards shall be complied with when operating this appliance.

Caution: Do not connect to any air distribution duct or system.

Warning: Never place wood, paper, furniture, drapes or other combustible materials within 80cm (311⁄2”) of the front of the unit, 20cm (77⁄8”) from each side, and 10cm (4”) from the back of the unit. Do not let children or pets touch it when it is hot.

To prevent the possibility of a fire, ensure that the appliance is properly installed by adhering to the installation instructions. An ENVIRO dealer will be happy to assist you in obtaining information with regards to your local building codes and installation restrictions.

FIRE EXTINGUISHER AND SMOKE DETECTION: All homes with a pellet burning stove should have at least one fire extinguisher in a central location known to all in the household. Smoke detectors should be installed and maintained in the room containing the stove. If it sounds the alarm, correct the cause but do not deactivate. You may choose to relocate the smoke detection devise within the room; DO NOT REMOVE THE SMOKE DETECTOR FROM THE ROOM.

CHIMNEY OR RUN AWAY FIRE: Call local fire department. Close the draft fully. Extinguish the fire in the burn pot liner with a cup of water and close the door. Examine the flue pipes, chimney, attic, and roof of the house, to see if any part has become hot enough to catch fire. If necessary, spray with fire extinguisher or water from the garden hose. IMPORTANT: Do not operate the stove again until you are certain the chimney and its lining have not been damaged.

OPERATION: The door and ash drawer must be kept closed when the unit is in operation to prevent fume spillage and for proper and safe operation of the pellet stove. Also ensure all gaskets on the door are checked and replaced when necessary.

FUEL: This pellet stove is designed and approved to only burn wood pellet fuel with up to 3% ash content. Dirty fuel will adversely affect the operation and performance of the unit and may void the warranty. Check with your dealer for fuel recommendations.

THE USE OF CORDWOOD IS PROHIBITED BY LAW.

SOOT: Operation of the stove with insufficient combustion air will result in the formation of soot which will collect on the glass, the heat exchanger, the exhaust vent system, and may stain the outside of the house. This is a dangerous situation and is inefficient. Frequently check your stove and adjust the slider/ damper as needed to ensure proper combustion. See: “SLIDER/DAMPER SETTING”.

CLEANING: There will be some build up of fly ash and small amounts of creosote in the exhaust. This will vary due to the ash content of the fuel used and the operation of the stove. It is advisable to inspect and clean the exhaust vent semi-annually or every two tons of pellets.

The appliance, flue gas connector and the chimney flue require regular cleaning. Check them for blockage prior to re-lighting after a prolonged shut down period.

ASHES: Disposed ashes should be placed in a metal container with a tight fitting lid. The closed container of ashes should be on a non-combustible surface, well away from all combustible materials pending final disposal. If the ashes are disposed of by burial in soil or otherwise locally dispensed, they should be retained in the closed container until all cinders have thoroughly cooled.

4

Page 3 Page 5
Image 4
Page 3 Page 5
Contents Evolution Table of Contents Introduction Store pellets at least 36 1 m away from the pellet stoveSafety Warnings & Recommendations USE of Cordwood is Prohibited by LAWSafety Warnings & Recommendations Specifications Hearth PadOperating Instructions Unit OverheatedManual Mode Special Notes Efficient FlameRoutine Cleaning and Maintenance Tools Required to Clean UnitDoor Glass Cleaning 2-3 days Burner POT and Liner 2-3 daysASH PAN and Door Gaskets weekly ASH PAN weeklyPellet Fuel in ASH PAN Exhaust Passages biannuallyPost Season CLEAN-UP Cleaning Plated SurfacesDoor Glass Replacement Control Board Error MessagesInstallation Data Sheet Name of Owner Address

50-1573 specifications

The Enviro 50-1573 is an innovative and eco-friendly solution aimed at addressing the growing needs of businesses and consumers alike. This product is designed with a focus on sustainability without compromising on performance or functionality.

One of the most notable features of the Enviro 50-1573 is its advanced energy efficiency technology. It uses state-of-the-art mechanisms to minimize energy consumption, making it an ideal choice for environmentally conscious users. Its design incorporates high-efficiency components that significantly reduce the carbon footprint while still delivering optimal performance. This efficiency not only helps the environment but also results in cost savings for users.

The Enviro 50-1573 is built using sustainable materials, which is a crucial characteristic for modern consumers. The use of recycled and non-toxic materials ensures that the product is safe for both the user and the planet. Manufacturers prioritize the lifecycle impact of their products, ensuring that they are designed to be recyclable or biodegradable at the end of their use.

In terms of technology, the Enviro 50-1573 incorporates smart features that enhance user experience. It includes an intuitive control system that allows users to monitor performance and make adjustments easily. This technology can be further integrated with mobile applications, allowing for remote operation and real-time tracking of energy usage and efficiency metrics.

Safety is another key characteristic of the Enviro 50-1573. It is designed with multiple safety protocols to protect users and surrounding environments, ensuring peace of mind during operation. These protocols include overload protection and automatic shut-off features, which help to prevent accidents and energy waste.

Moreover, the Enviro 50-1573 offers versatility, as it can be used in a variety of settings, from residential to commercial applications. Its streamlined design allows it to fit seamlessly into any environment without being obtrusive.

In conclusion, the Enviro 50-1573 stands out in the market for its commitment to sustainability, energy efficiency, and user-friendly technology. By prioritizing eco-friendliness alongside cutting-edge features, it meets the demands of today’s environmentally aware consumers while providing unwavering performance. Whether for home or business use, the Enviro 50-1573 represents a forward-thinking approach to products designed for a sustainable future.
Top Page Image Contents