Harman Stove Company TL 300 manual Chimney

Venting

	Non-combustible cover,
	one side only. If two
	covers are used, each
Hole with a minimum	must be mounted on
	non-combustible spacers
clearance of 18" (450 mm)
	at least 7/8" (21mm) away
between connector and
	from the wall.
wall.

1" (25mm) Clearance

AN APPROVED CANADIAN WALL

PASS-THROUGH

The Chimney

The TL300 must be installed into a chimney approved for use with solid-fuel appliances. In the U.S., the TL300 must be connected to (1) a prefabricated chimney complying with the requirements for Type HT chimneys in the Standard for Chimneys, Factory-Built, Residential Type and Building Heating Appliances, UL 103, or (2) a code-approved masonry chimney with a flue liner.

In Canada, the TL300 is listed for use with prefabricated chimneys tested and listed to the high temperature (650 degrees C) chimney standard, ULC S-629, or with a code approved masonry chimney.

For mobile homes,(US only) the TL300 must only be installed with prefabricated chimney systems, including the installation components, tested to use in mobile homes; the diameter should match the diameter of the

Closest	Minimum 2" (50mm)
Combusti-
ble Material	Clearance to Brick
	Liner	Minimum 12"
		(300mm) to Brick
	Flue	Fire Clay
		Thimble
	Chimney
		Chimney

Connector

Masonry Chimney Built to

NFPA 211 Specifications.

Minimum 12" (300mm) to Combustibles

AN APPROVED U.S.

WALL PASS-THROUGH

Do not connect this unit to a chimney

flue servicing another appliance.

NOTE: The restriction of not venting more than one appliance to the same flue applies to the U.S. specifically. While it is not recommended that you use the same chimney for more than one appliance, in Canada certain exceptions may be made. Be sure to contact your building code inspection official to see if this option is allowed in your area, and to find out the specific requirements for such an installation.

flue collar opening

The minimum recommended height for any chimney is 16 ft (4.8 m) above flue collar height. For non-mobile home installations, a round flue (either masonry or approved prefabricated), of either 6" (150 mm), 7" (180 mm) or 8" (200 mm) may be used. For square or rectangular masonry chimneys, nominal sizes of 8" x 8" or 8"x 12" (200mm x 200 mm, 200 mm x 300 mm) may be used.

Codes require that solid-fuel chimneys extend 3 ft (0.9

m) above the highest point at which they exit from the

roof. Then, the chimney must extend 2 ft.(6 m) above

the highest point within a 10 ft (3 m) radius. Thus, the

3 foot, 2 foot, 10 foot rule: 3ft. - Above roof exit point

2ft. - Higher than anything within-

More Than 10 ft. (3m)

10 ft. (3m)

2 ft. (0.6m) min.

Ridge

Chimney

Height Necessary Above Any Roof Surface Within 10ft. (3m)

3ft. (0.9m) minimum above

exit point

10ft. of the chimney.

The 3-foot, 2-foot, 10 foot rule

11Harman TL300