ASSEMBLY
When correctly placed, the logs and embers will look like the illustration below.
After the logs and embers have been placed, the next step is to replace the glass panel and frame. Carefully pick up the glass and glass frame assembly by grasp- ing the sides of the frame and using your thumbs and fingers to hold the glass in place within the gasket and frame.
With the glass frame (and glass) at a slight angle (leaving room for your fingers between the frame and the firebox) insert the bottom edge of the frame into the frame retainer located on the bottom front of the firebox. Take care to center the frame from left to right. Once the bottom edge is in place, move your fingers out of the way and press the top of the frame against the firebox while pushing down to be sure the frame is fully engaged in the frame retainer. Hold the frame in place with one hand and engage the three glass frame latches by pulling out and down while hooking them over the frame.
Top or Rear Vent
LATCHING DETAIL- PULL FORWARD AND DOWN TO HOOK LATCH OVER GLASS FRAME
The FireLuxe has provisions for either top or rear venting but is shipped from the factory
Remove the four screws that secure the vent starter section flange to the stove and remove the starter. There are two ceramic fiber gaskets that seal the starter to the stove. These gaskets are very important! Take care in handling these gaskets as they are somewhat fragile and will tear. Remove the vent cover plate from the rear of the stove following the same procedure as the starter. Install the cover plate on the top vent opening.
17