Char-Broil 5101194 manual Machine screws

Page 14

Step 3

Position rotary ignitor as shown below. Attach ignitor behind control panel using two #8x1/2” self-tap screws.

Rotary ignitor 55700666

#8x1/2”

Self-Tap Screw

Qty: 2

Control panel 55700671

#8x1/2” Self-Tap Screw

Step 4

Insert valve/hose through front opening and attach to control panel using two #8-32x3/8”

machine screws.

NOTE: Screws may already be installed in valve and must be removed to attach valve to control panel.

#8-32x3/8” Machine Screw

Hose/Valve/Regulator assembly 55700665

#8-32x3/8”

Machine Screw

Qty: 2

14

Image 14

Contents

To installer or assembler To consumer If you smell gasSafety Symbols Use and CareTable of Contents Must meet the following requirements LP CylinderLP cylinder used with your Outdoor Stove Top Odor similar to rotten cabbage so that it can beConnecting Regulator To The LP Cylinder LP Cylinder ExchangeSafety Tips RegulatorBurner Flame Check Light burner, rotate knob Use appliance at least 3 ftApartment Dwellers Burner CheckIf you experience the following Natural Hazard SpidersTypical spider webs inside burner Care and Cleaning of Stainless Steel Troubleshooting Problem Possible Cause Prevention/Cure Parts List Key Qty DescriptionParts Diagram Assembly Machine screws Figure a Base Cover assembly #8x1/2 29100873 Self-Tap Screw Qty Page Please register your product online at Char-Broil, LLC Columbus, GA 31902 Assembly Instructions