Care and Maintenance
As the hob has a stainless steel or enamel surface, you should use a nonabrasive cleaner. Any abrasive cleaner (including Cif) will scratch the surface and could erase the control panel markings. Stainless steel can be effectively cleaned by simply using a dilute solution of water and mild detergent and drying to a shine with a clean cloth.
Over time with use, the stainless steel surface may discolour; this is normal and does not constitute a fault with this ap- pliance. Proprietary stainless steel cleaners are available. We recommend the CDA
The enamelled parts of hobs are not suitable for cleaning in dishwashers; these should be washed by hand.
IMPORTANT:
•Steam cleaners must not be used when cleaning this appliance.
•Ensure that all parts are correctly replaced after cleaning before attempting to use the hob.
•After removing the pan stands, ensure the rubber pads are in place on the base of the pan stand before repositioning the pan stands straight and level on the hob.
What to do if you smell gas:
1. Open doors and windows
2. Turn the gas supply off
3. Call Transco on : 0800 111 999
Burner Size | Nominal Rating | Simmer Rating | |
| (kW) | (kW) | |
|
|
| |
Auxiliary | 1.0 | 0.45 | |
|
|
| |
1.75 | 0.6 | ||
|
|
| |
Rapid | 3.0 | 0.9 | |
|
|
| |
Triple Ring | 3.6 (HCG622) / 3.5 (HCG612) | 1.6 | |
|
|
|
Total rated gas input (HCG602) : 7.5kW
Total rated gas input (HCG612) : 8kW
Total rated gas input (HCG622) : 8.1kW
Mains electrical voltage: 230 – 240Vac
Total rated electrical consumption: <1W
If your Hob is not working
1.Check that the mains supply has not been switched off.
2.Check that the fuse in the spur has not blown.
3.Ensure that the burner components are not excessively soiled as this can lead to ignition problems.
Contact CDA Customer Care
A : Customer Care Department, The CDA Group Ltd, Harby Road, Langar, Nottinghamshire, NG13 9HY
T : 01949 862 012 F : 01949 862 003 E : service@cda.eu W : www.cda.eu