Cumberland Stove Works OMMF3500 Unpacking and Assembly, Mount Legs, Mount Handle to Hopper Door

Page 11

INSTALLATION AND OPERATION MANUAL

MF3500G, MF3500S, MF3500B Models

UNPACKING AND ASSEMBLY

The MF3500 parlor stove is bolted to a skid to prevent movement during shipping. To free the stove from the skid you must remove the two hold-down bolts in the base of the unit.

Unpack all hardware located in the units hopper. The following should be included:

(4) legs w/ leveler

hopper lid handle

(12) leg bolts

power cord

(4) tie-down straps

round vent transition

(4) tie-down bolts

gasket for round vent

ash shuttle rod

(4) 1/4-20 x 1/2” bolts

spring for ash shuttle rod

(2) hopper lid handle

 

bolts

MOUNT LEGS

Leg Assembly

 

1.Gently tilt the stove on the side opposite of the controller.

2.Assemble the legs using provided (12) leg bolts as

shown.

NOTE: If unit is to be used in a mobile home, you must install the (4) tie-down straps to the stove now. Refer to page 13 for instructions.

3. After all bolts have been tightened properly, set the stove

Hopper Door Handle Assembly

 

back up on its legs.

 

MOUNT HANDLE TO HOPPER DOOR

1. Using a Phillips screwdriver, attach hopper handle to hopper door using pre-drilled holes.

ASSEMBLE ASH SHUTTLE ROD

1.Thread spring over non-threaded end of rod.

2.Place threaded end of ash shuttle rod through decorative casting and screw into fire pot.

Ash Shuttle Rod Assembly

800-345-6007

CumberlandStoveWorks.com

Page

Page 10 Page 12
Image 11
Page 10 Page 12
Contents Multi Fuel Parlor Stove Page Table of Contents Limited lifetime Warranty WarrantyOwnership Records REGISTRATION, Service and Maintenance LOGCumberlandStoveWorks.com Power Outage Automatic Safety FeaturesBurning Solid Fuels IntroductionWood Pellets Glass Specifications SpecificationsAssemble ASH Shuttle ROD Unpacking and AssemblyMount Legs Mount Handle to Hopper DoorMount Round Exhaust Transition Plug in Power CordFloor Protection Requirements InstallationStove Placement Clearances to Combustibles Mobile Home Outside AIR ConnectionType of Vent Pellet Vent InstallationVenting Vent Termination Clearances Venting Installation ExamplesUnderstanding the TRI-X Controller Operating InstructionsADD Fuel KEY Understanding the Normal Heat ScreensCorn AS Fuel Push AUX 1 to SET Starting Fire Level Shutdown Sequence of Events Startup Sequence of EventsLighting the Stove Lighting ProcedureTurning the stove off Normal Care & Maintenance Seasonal Cleaning Daily MaintenanceWeekly Maintenance Ordering Repair Parts Troubleshooting & repairProblem Cause Too rich air/fuel mixture Troubleshooting GuideProblem Cause Loss of vacuum Startup Check Exhaust OFF Understanding the Fault ScreensMain Assembly Parts KEY # Description ASH PAN Parts Glass Door PartsCirculating AIR Duct Parts Exhaust Parts Auger Parts Electric Panel Parts Wiring Diagram Ardisam
Top Page Image Contents