MAINTENANCE
CAUTION :
Always be sure that the tool is switched off and unplugged before attempting to perform inspection and maintenance.
Replacing carbon brushes
0 Remove and check the carbon brushes regularly. Replace when they wear down to about 6 mm (1/4") or less. Keep the brushes clean and free to slip in the holders. Both brushes should be changed a t the same time. Use only Makita carbon brushes.
k 4
6mm (1 /4")
0 Use a screwdriver to remove the brush
holder cap as shown on the figure. | BNSh holder cap |
|
.Take out the worn brush, insert the new one and secure the brush holder cap.
Any other maintenance should be performed by an Authorized Makita Service Center or point of purchase.
10