ADDITIONAL SAFETY RULES
1.These bits come fully sharpened. Handle them carefully t o prevent injury.
2.Check the bit carefully for cracks or damage before operation. Replace cracked or damaged bit immediately.
3.Avoid cutting nails. Inspect for and remove all nails from the workpiece be- fore operation.
4.Make sure the shaft lock is released before the switch is turned on.
5.Hold the tool firmly with both hands.
6.Keep hands away from rotating parts.
7.Check the bit is not contacting the workpiece before the switch is turned on.
8.Before using the tool on an actual workpiece, let it simply run for several minutes first. Watch for flutter that might be caused by poor installation or a poorly balanced.
9.Be careful of the bit rotating direction and the feed direction.
IO. Do not leave tool running. Operate the tool only when
11.Always switch off and wait for the bit to come to a complete stop before removing the router from workpiece.
12.Do not touch the bit right after operation, it is extremely hot and could burn your skin.
13.Keep the bit retracted so as not to protrude from the bottom except during actual operation.
SAVE THESE INSTRUCTIONS.
4