Stopper block
.The stopper block has an adjustment hex bolts which move 1 mm (1/32")per turn. After obtaining the desired depth setting, tighten the hex nut on the bolt with the spanner.
I | \ | block |
|
Nylon nut
By turning the nylon nut, the upper limit of the tool can be adjusted. When the tip of the bit is retracted more than required in relation to the base plate surface, turn the nylon nut to lower the upper limit for more effective routing.
CAUTION :
0 Do not lower the nylon nut too low or the bit will dangerously protrude.
0 Before operating the tool, check to be sure that the router automatically rises to the upper limit.
Switch action
*To start the tool, position the switch lever to "ON" side. To stop, to "OFF" side.
CAUTION |
|
Prevent accidental starting by making | Switch lever |
sure the tool is switched off before you |
|
plug it in. |
|
6