Delta 78-904, 78-907) instruction manual

T

U V

T

Fig. 16

13. After the holes have been drilled in the edge of the front and rear extension table board, fasten both front and rear rail to table using the 1-1/2 flat head Phillips screws (T) Fig. 16, 1-1/4 O.D. flat washers (U) and hex nuts (V).

14.If you are assembling the T-Squarefifence to a Delta Unisawfi that has the on-off switch (W) Fig. 17, suspended from the bottom of the saw table, as shown, remove the switch and nipple (W) from the bottom of the saw table.

15.Assemble the switch and nipple (W) Fig. 18, to switch adapter for Unisaws (X) supplied with your T-Square fence.

16.Figure 19 illustrates the switch and nipple (W) assembled to the switch adapter (X). The switch adapter will be fastened to the front rail (A) and guide tube through holes (Y) in the front rail after the guide tube is fastened to the front rail (A).

W

X

Fig. 17

A

Y

X

Z

W

W

Fig. 18 Fig. 19