Casablanca Fan Company 55020, 59095, 59096, 59097 operation manual Hand Tighten

Page 8

Downrod (continued)

www.CasablancaFanCo.com

1.888.227.2178

					E





					K	E
					K	P
							!

Remove the pre-installed

setscrew so that the downrod

can be inserted.

Hand tighten the downrod (at least 4-5 full turns) until it stops.

8”

The wires can be cut, but leave at least 8” extending from the top of the downrod.

Tighten the setscrew with pliers. DO NOT

HAND TIGHTEN.

3/8”

If the setscrew is not tightened securely, the fan may fall.

8

M6011-01 • 10/30/14 • © Casablanca Fan Company

Image 8

Contents Table of Contents What to Expect with Your Installation Tools Needed Mounting Options Ceiling Bracket For angled ceilings, point Opening toward peakPreparation Downrod Hand Tighten Put the wires and downrod through the canopy Do not Pick the FAN UP byWiring Assembly as shownOr common Using an orange wire connector fromHardware bag After Wall ControlBefore Canopy HolesBlades Blades sold separatelySwitch Housing Which two screw holes you choose Twist counterclockwiseConnectors Switch housing screws, found Operation Maintenance & Cleaning Reverse ButtonTroubleshooting Fan doesn’t work