Troubleshooting (continued)
Installing Multiple Fans with Independently Operating Remote Controls
To install multiple fans with independently operating remote controls, there is no need to perform any pairing procedures. Each set of receiver/transmitter is already paired. Simply install each receiver into a fan and use the appropriate transmitter to operate each fan.
If your remote is not working, see the “Remote does not work” section on the previous page.
Installing Multiple Fans Operating on a Single Remote Control
www.CasablancaFanCo.com 1.888.227.2178 
Installing One Fan Operating on Multiple Remote Controls
To have multiple remote controls operate one fan, you must pair each additional transmitter
to the receiver in the fan. The transmitter that shipped with your fan is already paired.
Note: To prevent faulty operation, please disconnect power (at the wall switch,
breaker, or fan) from all other ceiling fans within range while pairing.
For each additional transmitter, cycle power to the fan by turning power off and back on at the wall switch (or circuit breaker if necessary). Within three minutes, press and hold both the Fan Off button and the 4 button for four seconds to pair the remote. If applicable, the fan will turn on and the lights will flash and stay on to indicate successful pairing.
“Unpairing” Procedure for Faulty Operation of Remote Controls
X
To have multiple fans operated by a single remote control, you must pair the transmitter to each additional receiver. The receiver that shipped with your fan is already paired to the transmitter.
Note: To prevent faulty operation, you MUST disconnect power (at the wall switch, breaker, or fan) from all other ceiling fans within range while pairing each fan.
If a transmitter is mistakenly operating a fan, you need to “unpair” the transmitter from that
fan’s receiver. The “unpairing” procedure is the same as the pairing procedure.
Note: To prevent faulty operation, you MUST disconnect power (at the wall switch, breaker, or fan) from all other ceiling fans within range while “unpairing” a fan.
For each additional fan, ensure that a compatible receiver is installed. Disconnect power from all | Disconnect power from all other fans while “unpairing.” Then, cycle power to the fan you |
other fans while pairing. To pair: cycle power to the fan by turning power off and back on at | wish to “unpair” by turning power off and back on at the wall switch (or circuit breaker |
the wall switch (or circuit breaker if necessary). Within three minutes, press and hold both | if necessary). Within three minutes, press and hold both the Fan Off button and the 4 |
the Fan Off button and the 4 button for four seconds to pair the remote. If applicable, the | button for four seconds to “unpair” the remote. If applicable, the fan will turn off and the |
fan will turn on and the lights will flash and stay on to indicate successful pairing. | lights will flash and turn off to indicate successful “unpairing.” |
20