Casablanca Fan Company 59109 operation manual Canopy, Holes

Page 13

Canopy

www.CasablancaFanCo.com

1.888.227.2178

Position the canopy so that, when lifted into place, the canopy fits into the hanging bracket as shown.

Screw

Holes

Lift the canopy into place so that

the screw holes are aligned.

Insert the two canopy screws

found in the

hardware bag.

13

M8518-01 • 10/30/14 • © Casablanca Fan Company

Image 13

Contents Table of Contents What to Expect with Your Installation Tools Needed Support Structure Standard Ceiling Mounting Standard Mounting AngledTo hang the fan from a For angled ceilings, point Opening toward peak Ceiling BracketPreparation Steps 1-5 to remove standard downrod pipe DownrodSteps 6-10 to reassemble with new pipe Tighten the setscrew Remove the pre-installed Hand tighten the downrod atSetscrew so that the downrod Leave at least 8 extendingDo not Pick the FAN UP by Put the wires and downrod through the canopy Assembly as shown WiringHardware bag Using an orange wire connector fromOr common Before Wall ControlAfter Holes CanopyBlade Iron BladesMay damage the finishes Light Kit Notch TabOperation Battery Holder DoorFan Battery HolderSpeed Lights DownOFF Maintenance & CleaningFan doesn’t work Troubleshooting