Casablanca Fan Company 59109 operation manual Operation, Battery Holder Door

Page 17

Operation

www.CasablancaFanCo.com

1.888.227.2178

Battery

Battery

Holder

Battery

Door

Before operating the wall control, press on the battery door to eject it. Unscrew the battery holder. Insert the battery, found in the control hardware bag, with the positive (+) side facing downward. Reinstall the battery holder and reinsert the battery door into the wall control.

ON

The remote transmitter should already be paired

to the receiver and ready to use.

Note: If your need to pair your remote, turn fan power off and back on at the circuit breaker. Within three minutes, press and hold both the Fan Off button and the 4 button for four seconds to pair the remote. To prevent faulty operation, please disconnect power from all other ceiling fans within range while pairing.

17

M8518-01 • 10/30/14 • © Casablanca Fan Company

Image 17
Contents Table of Contents What to Expect with Your Installation Tools Needed To hang the fan from a Standard Mounting AngledSupport Structure Standard Ceiling Mounting For angled ceilings, point Opening toward peak Ceiling BracketPreparation Steps 6-10 to reassemble with new pipe DownrodSteps 1-5 to remove standard downrod pipe Tighten the setscrew Remove the pre-installed Hand tighten the downrod atSetscrew so that the downrod Leave at least 8 extendingDo not Pick the FAN UP by Put the wires and downrod through the canopyAssembly as shown WiringOr common Using an orange wire connector fromHardware bag After Wall ControlBefore Holes Canopy May damage the finishes Blades Blade Iron Light Kit Notch TabOperation Battery Holder DoorFan Battery HolderSpeed Lights DownOFF Maintenance & CleaningFan doesn’t work Troubleshooting