Casablanca Fan Company III manual Ceiling Hardware, Getting Started

ESTRADA

CEILING HARDWARE

CROSSBAR	WIRE NUT (4)
MOUNTING
BRACKET

ADDITIONAL HARDWARE

21/4″ x 8-32 ROUNDED

HEAD SCREW (2)

1″ x 8-32 ROUNDED	FLAT WASHER (2)
HEAD SCREW (2)

GETTING STARTED

Installing a New Ceiling Fixture Outlet Box

If you do not have an existing fixture located where you wish to place your Casablanca fan, an approved ceiling fixture outlet box must be installed and wired.

Warning: To reduce the risk of fire, electrical shock, or personal injury, mount to outlet box marked acceptable for ceiling fan support using the mount- ing hardware provided with the outlet box.

Using Existing Ceiling Fixture Outlet Box

After turning the power OFF at its source (either circuit breaker or fuse box), lower the old fixture and disconnect the wiring. Check the ceiling fixture outlet box to be sure that it is marked ‘Approved for ceiling fan mounting’. If it is not, a new box must be installed.

CROSSBAR MOUNTING BRACKET INSTALLATION

WARNING: Damp Location rated fans require a Ground Fault Interrupter (GFI). Use a weather-proof outlet box, properly connect ground wires, and use only under a weather-proof structure.

Proceed with installation as follows:

Step 1. Route the wires from the ceiling outlet box through the crossbar mounting bracket center hole. Attach the bracket, with ground wire and ridges down, to the ceiling fixture out-

CEILING FAN

APPROVED

OUTLET BOX

CEILING

WIRING

let box with the mounting hardware included with the outlet box.

Using the screwdriver, tighten the screws firmly by hand only, being careful not to bend the bracket by over tightening.

CROSSBAR MOUNTING BRACKET

RIDGE SIDE DOWN

CAUTION: To reduce the risk of personal injury, use only the mounting hardware provided with the approved outlet box to install the crossbar mounting bracket.

FLAT

WASHER

GREEN

GROUND

WIRE

OUTLET BOX

MOUNTING

HARDWARE

	CANOPY HARDWARE
		CANOPY SCREW (4)
CANOPY		CANOPY LOCK WASHER (4)
HATCH	CANOPY

4