MODE
According to the selected input signal, there are several picture setup options available: Presentation mode, Video mode, Cinema mode and Lamp Low mode. Refer to page 25 for more information.
Remote Control Effective Range
Infra Red (IR) remote control sensors are located on the front and the back of the projector. The remote control must be held at an angle within 30 degrees of the projector’s IR remote control sensors to function correctly. The distance between the remote control and the sen- sors should not exceed 6 meters (19.5 feet).
6m
Important:
Notes on Remote Control Operation:
Make sure that there are no obstacles between the remote control and the IR sensors on the projector that might obstruct the
Installing or Replacing the Battery
1.Pull out the battery holder while sliding the lock in the direction of the arrow using a pointed stick such as a ball point pen.
2.Insert the new battery in the holder.
3.Push the holder into the remote control.
•Use of a battery of wrong type may cause explosion. Use type CR2025 only.
•Dispose of used batteries according to your local regulations.
Lock
Battery holder
•Batteries may explode if misused. Do not recharge, disassemble, or dispose of in fire.
•Be sure to handle the battery according to the instructions.
•Load the battery with its positive (+) and negative
•Keep batteries out of reach of children and pets.
•Remove the battery, if the remote control is not used for a long time.
10 Introduction
