Source Selection
To sequentially select input sources, press SOURCE on the projector control panel or the remote control. It may take you a few seconds when the projector is searching for input signals. The selected source will be displayed at the bottom right of the screen for 3 seconds. For a quick search, you can also press the key repeatedly until your desired signal is displayed.
Auto Adjustment
In some cases, you may need to optimize the picture quality. To do this, press AUTO POSITION on the control panel of the pro- jector or AUTO on the remote control. Within 3 seconds, the
The current source information will be dis- played at the bottom right of the screen for 3 seconds, as below.
Important:
•The screen will be blank while Auto is functioning.
•You can use Auto Adjustment function when only source is Analog RGB.
20 Operation
