Casablanca Fan Company 54031, 54032, 54033 operation manual Canopy, Holes

Page 13

Canopy

www.CasablancaFanCo.com

1.888.227.2178

Position the canopy so that, when lifted into place, the canopy fits into the hanging bracket as shown.

Screw

Holes

Lift the canopy into place so that

the screw holes are aligned.

Insert the two canopy screws found in thehardware bag.

Note: Fan style may vary.

13

M6010-01 • 10/30/14 • © Casablanca Fan Company

Image 13

Contents

Table of Contents What to Expect with Your Installation Tools Needed Ceiling Standard Support Mounting StructureOutlet Box AngledFor angled ceilings, point Opening toward peak Ceiling BracketPreparation Steps 1-5 to remove standard downrod pipe DownrodSteps 6-10 to reassemble with new pipe Tighten the setscrew Remove the pre-installed Hand tighten the downrod atSetscrew so that the downrod Leave at least 8 extendingDo not Pick the FAN UP by Put the wires and downrod through the canopyAssembly as shown WiringHardware bag Using an orange wire connector fromOr common Before Wall ControlAfter Holes CanopyBlades Switch Housing Light Kit Want to install your fan without a light kit?Shade Operation Battery Holder DoorFan Battery HolderSpeed Lights DownLight Pull Maintenance & CleaningChain Fan doesn’t work Troubleshooting