Casablanca Fan Company 54033, 54032, 54031 Remove the pre-installed Hand tighten the downrod at

Page 8

Downrod (continued)

E

 

K

E

 

P

 

 

!

www.CasablancaFanCo.com

1.888.227.2178

Remove the pre-installed

Hand tighten the downrod (at

The wires can be cut, but

Tighten the setscrew

setscrew so that the downrod

least 4-5 full turns) until it stops.

leave at least 8” extending

with pliers. DO NOT

can be inserted.

 

from the top of the downrod.

HAND TIGHTEN.

8”

8

3/8”

If the setscrew is not tightened securely, the fan may fall.

M6010-01 • 10/30/14 • © Casablanca Fan Company

Page 7 Page 9
Image 8
Page 7 Page 9
Contents
Table of Contents What to Expect with Your Installation Tools Needed Standard Support Mounting Structure CeilingOutlet Box AngledCeiling Bracket For angled ceilings, point Opening toward peakPreparation Steps 6-10 to reassemble with new pipe DownrodSteps 1-5 to remove standard downrod pipe Remove the pre-installed Hand tighten the downrod at Tighten the setscrewSetscrew so that the downrod Leave at least 8 extendingPut the wires and downrod through the canopy Do not Pick the FAN UP byWiring Assembly as shownOr common Using an orange wire connector fromHardware bag After Wall ControlBefore Canopy HolesBlades Switch Housing Want to install your fan without a light kit? Light KitShade Battery Holder Door OperationBattery Holder FanSpeed Lights DownChain Maintenance & CleaningLight Pull Troubleshooting Fan doesn’t work