Casablanca Fan Company 54031, 54032, 54033 Fan, Speed, Lights Down, Battery Holder, Reverse Button

Page 19

Operation (continued)

www.CasablancaFanCo.com

1.888.227.2178

Fan

(Low)

Fan

 

Speed

 

Speed

 

 

(High)

Lights

 

Lights

Down

 

Up

Reverse

 

Fan

 

 

Power

Battery

Holder

Quickly press the up or down arrow to turn the lights off and on. Hold the up or down arrow to raise or dim the light level. The reverse button changes the direction that the blades turn. The power button turns the fan off and on.

Reverse

Button

(a)

(b)

The reverse button on the wall control changes the air flow pattern. In warm weather, use

(a)downward air flow pattern.

In cold weather, use (b) upward

air flow pattern.

The Safe-Exit Program gives you about thirty seconds of light when you turn the lights off to exit the room before the

lights go out.To use Safe-Exit:

Press the fan power button off for at least three seconds to initiate the Safe-Exit Mode.

The lights will flash for visual confirmation.

The lights will stay on 50% brightness for 20 seconds and then begin to dim. After a total of 30 seconds, the lights will be completely off.

19

M6010-01 • 10/30/14 • © Casablanca Fan Company

Image 19 Contents
Table of Contents What to Expect with Your Installation Tools Needed Angled Standard Support Mounting StructureCeiling Outlet BoxFor angled ceilings, point Opening toward peak Ceiling BracketPreparation Steps 1-5 to remove standard downrod pipe DownrodSteps 6-10 to reassemble with new pipe Leave at least 8 extending Remove the pre-installed Hand tighten the downrod atTighten the setscrew Setscrew so that the downrodDo not Pick the FAN UP by Put the wires and downrod through the canopyAssembly as shown WiringHardware bag Using an orange wire connector fromOr common Before Wall ControlAfter Holes CanopyBlades Switch Housing Light Kit Want to install your fan without a light kit?Shade Operation Battery Holder DoorLights Down Battery HolderFan SpeedLight Pull Maintenance & CleaningChain Fan doesn’t work Troubleshooting