Hole to Front
●G
●M
●I
●O
●H
FIG. 1
FIG. 2
●N
ENGLISH
HOW TO ASSEMBLE
Assemble completely and charge batteries for
CAUTION: Use only Eureka charger model
Have a screwdriver available for assembly (not included).
Attach Handle Grip (Fig. 1)
Step 1: Locate the 2-part bolt ●H in the assembly package.
Step 2: Align the handle grip and handle tube holes and secure with the
Note: The single hole in the handle tube faces forward in relation to the handle grip.
Attach Handle (Fig. 2)
Step 1: Use your thumb to pull back on the lock button ●M .
Step 2: Push handle ●G into top of cleaner.
Step 3: Release lock button ●M and rotate handle ●G until it locks into place.
Secure Wall Bracket on Wall (Fig. 3)
Have a 1/4 inch drill available for assembly (not included). Cleaner hangs in bracket with the nozzle end down. Mount on a wall in close proximity to an electrical outlet where there are not dangerous objects hidden beneath the wall surface like electrical wires, pipes, etc. Leave 14 inches above the floor for clearance.
Step 1: Hold bracket ●I against wall to mark location for screws. Make sure the wall bracket is positioned vertically, with the charger socket at the bottom.
Step 2: Use a 1/4 inch drill for drilling holes for the plastic anchors ●N .
Step 3: Insert the anchors ●N and drive the screws ●O into both holes.
●L
FIG. 3
●C
Step 4: Tighten the screws ●O to secure the bracket ●I .
Step 5: Place cleaner, with the nozzle pointed down, on the wall bracket ●I .
Step 6: Plug the charger ●L into an electrical outlet.
Note: This charger has been designed to use as either a wall mounted charger or to sit on a counter or shelf ●P . To use on a counter or shelf, locate next to an electrical outlet. Take the battery ●C out of the cleaner and put in the counter bracket ●I . The charge light ●J or ●K will indicate that the battery is charging (Fig. 4).
●I
|
| ● |
|
| P |
● | K |
|
J | ● | FIG. 4 (CONTINUED) |
8 |
|