Eureka 5890 How to Maintain YourVacuum Cleaner, Maintain Brush Roll, Brush Roll Reset Button

How to Maintain YourVacuum Cleaner

! Make sure vacuum cleaner is turned off and power cord is unplugged

Maintain Brush Roll

Motor can become hot with normal use.

Do not remove end caps. Remove hair and threads from brush roll periodically.

Check Cogged Belt. Replace if worn or broken

! Avoid touching the motor shaft when checking brush roll or belt.

How to replace brush roll or belt

1) Adjust carpet height setting to the lowest or highest position.

2) Press handle release twice to lower handle flat onto floor (Fig. 1).

3) Turn vacuum over.

4)	Remove 6 screws from the backside	Fig. 1
	of cover (Fig. 2). One screw is
	located under the wheel carriage.
5)	Turn vacuum back over to front side
	and lift off brush roll cover (Fig. 3).
6)	Lift left end of brush roll first.
	Remove old brush roll and belt.
7)	Thread belt around motor shaft
	(Fig. 4). Place belt around the
	pulley of new brush roll.	Fig. 3
8)	Align brush roll left end cap with
	base and push into place. Push right
	end cap into base until it snaps into
	place (Fig. 5).
9)	Rotate brush roll 2 turns to position
	belt properly.
10)	Replace brush roll cover (Fig.3).
11)	Turn vacuum over and replace 6	Fig. 5
	screws (Fig. 6).

Fig. 2

Fig. 4

Fig. 6

Brush Roll Reset Button

1)Clear interference that caused brush roll to stall.

2)Press reset button on the side of vacuum below brush roll cover (Fig. 7).

Fig. 7

4 Eureka Customer Service HELPLINE 1-800-282-2886 www.eureka.com