Eureka 5829, 5700, 5739, 5800 warranty Brush Roll Belt, Style U

Brush Roll

The brush roll turns as it sweeps and combs the carpet nap. Remove hair and threads from the brush roll so it continues brushing the carpet. To maintain the most efficient cleaning, the bristles must touch the carpet. To test the bristle length, hold a ruler against the underneath side of the cleaner. If the bristles no longer touch the ruler, replace the brush roll.

Brush Roll Belt, Style U

The brush roll belt turns the brush roll to agitate, sweep, and comb the carpet nap. Check the belt regularly to be sure it is in good condition. Replace the belt if it stretches, cracks or loses tension. Cut away any hair or threads wound around the brush roll or the belt pulley because the buildup could cause the belt to rotate unevenly.

How To Replace Brush Roll Belt
	NOTE: Turn off the switch and unplug the
	electrical cord before replacing belt. Belt pulleys
	can become hot during normal use. To prevent
PERIODIC	injury, avoid touching the motor shaft when
	changing the belt.
MAINTENANCE		1
		2
		2
Brush		2
	1. Lower handle to floor to change belt.
	2. Remove three screws indicated by screwdrivers in
	above illustration. Lift hood to remove.
Roll	NOTE:	The carpet height adjustment has to be in
	the lowest or highest position to remove or reinstall
	the hood.

Brush	4
Roll	Motor
Belt	Shaft
	Belt
	Brush
	Roll
	3

3.Lift left end of brush roll.

4.Remove and discard belt.

12

5

5. Place new belt around motor shaft.

7

8

6

6.Place belt around brush roll pulley.

7.Align left end cap with base. Push end cap securely into place.

8.Pull right side of brush roll to stretch belt. Secure right end cap into base.

9

IMPORTANT

9.Rotate brush roll by hand two full rotations to properly position belt.

10.Place hood back on cleaner. Make sure hood front is behind furniture guard. Replace three screws.

11.Tighten screws.

Use GENUINE EUREKA replacement belt, Style U. Look for the GENUINE EUREKA product symbol.