To Clear Blockages in Hose
|
| Nested |
|
| Wands |
|
| Hose |
|
| Adapter |
|
| Tabs |
PROBLEM | NOTE: Turn off the switch and unplug the electrical | |
| ||
SOLVING |
| cord before clearing hose. |
1 | Locate upper hose adapter on the back of the | |
|
| cleaner. |
| 2 | Remove nested wands from back of cleaner for easy |
|
| access to hose adapter tabs. |
Clear | 3 | Press hose adapter tabs together and pull hose |
| adapter away from cleaner. The hose adapter will | |
|
| |
|
| unscrew off hose for easy access to debris if |
|
| necessary. |
Hose | 4 | Check for blockages at cleaner opening and in hose. |
| If no blockage is found, continue to step 5. If | |
|
| |
|
| blockage is found, clear and continue to step 11. |
14 |
|
|
Lower
Hose
Adapter
Base
Hose
5Locate lower hose adapter on the back of the cleaner.
6Remove lower hose adapter from rear of cleaner by lifting up and twisting.
7Check for blockages in the hose and base hose. Flexing the hose may help loosen any blockage. If no blockage is found, continue to step 8. If blockage is found, clear and continue to step 11.
▲ |
8Remove hood from cleaner and check for a blockage in the brush roll area. Make sure the hose inlet is clear.
9After the blockage is found and cleared, replace the hood on the cleaner.
10Place lower hose adapter back into the base hose. Install the upper hose adapter onto the back of the
11cleaner, line it up with the cleaner opening and push it against the cleaner until both tabs lock into place.