AOSafety E-A-RTONE 3A manual Preliminary Procedures for Use of the E-A-RTONE3A, Rlink

1. Preliminary Procedures for Use of the E-A-RTONE®3A

Initially examine the ear canal for obstruction(s) and evaluate the proper size E-A-RLINK®disposable foam eartip needed to fit the particular ear canal. Although the standard E-A-RLINK®3A fits most ear canals, for smaller ear canals, the smaller diameter E-A-RLINK®3B eartips are available. It is important to obtain a good seal and achieve the proper insertion depth. Insertion procedures are the same for the E-A-RLINK®3A and E-A-RLINK®3B, but deep insertion may be difficult to achieve in extremely small ear canals. In these instances, a shallow placement will have to suffice.

Secure the section of black tubing, which protrudes from the

E-A-RLINK®eartips to the sound tube nipple located at the end of the E-A-RTONE®sound tube.

Slowly roll the E-A-RLINK®tip into the smallest diameter possible and insert the E-A-RLINK®well into the ear canal (see illustrations).

Since the eartips are 12 mm long, the correct insertion depth into the ear canal is obtained when the rear edge of the E-A- RLINK® is

2-3mm inside the entrance of the ear canal.

Hold E-A-RLINK®in ear canal until expanded.

After the test is completed, remove the E-A-RLINK®eartips and replace with a new pair for the next subject.

E-A-RLINK®

Full InsertionShallow Insertion

Proper insertion depth is necessary to achieve maximum ambient noise attenuation and interaural attenuation. The graph below depicts interaural attenuation as a function of insertion depth. The described interaural attenuation is obtained for each ear in which the E-A-RLINK®is fully inserted, regardless of whether it is the “sending” ear or “receiving” ear.

2