HOW to Assemble, Attach Handle, Insert Battery

HOW TO ASSEMBLE

Attach Handle

1.Locate the handle and body.

2.Line the handle up with the hole in the top of the body. Flat side of handle and loop forward.

3.Push handle down into body while pressing button on back of the body. Handle will click into place.

4.There are two handle positions available. Handle all the way up and handle all the way down.

5.Button needs to be depressed to raise and lower the handle.

Insert Battery

Hold battery so thumb is positioned on thumb grip button and push completely into body until battery clicks into place.

To Remove Battery

Grasp end of battery using thumb grip and pull out of body.

NOTE: Charge the batteries for 14-16 hours before initial use. A cleaner may lose charge in shipment. The charger body will become warm, however, this is not a cause for concern.

NOTE: For extended battery run time and to prevent long fringe of some area rugs from wrapping around brush roll, place switch in floors (brush roll off) position.

NOTE: Cleaner will not run when charger is connected and battery is in the unit.

CAUTION: To avoid risk of fire, use only genuine Eureka replacement battery packs.

Loop

Handle

Button

Body

Thumb Grip

Button

Body

Battery Thumb

Grip Button