Assembly Parts
4
3
1 | Wand and Crevice Wand. (Pull apart.) |
2 | Dusting Brush. |
3 | Hose. |
4 | Vacuum Cleaner Body. |
5 | Electrical Cord. |
2
5
6 | Handle. |
7 | Screws located in the accessory package. |
1
6
How To Assemble
CAUTION: Assemble the cleaner before using.
CAUTION: Moving parts, make sure ON/OFF switch is in the OFF position before plugging in.
1 Grasp dust bag cover handle and pull away from vacuum body to remove door.
2 Slide the handle into the grooves at the top of the vacuum body as shown.
3 Place the two screws (supplied)into the holes at the top of the bag compartment and tighten with a screwdriver.
4Place the tabs on the bottom of the dust bag cover into slots at the bottom of the bag compartment and rotate door up and push against the vacuum body until it snaps shut.
5 Place the hose on the back of the vacuum, wrapping it up and over the hose hook as shown.
6Firmly push the end of the hose into the hose retainer in the hood of the vacuum.
www.eureka.com | 3 |