Hoover SteamVac LS manual Assemble handle, Attach upper handle, Attach hose clip

The assembled cleaner will look like this drawing.

1-4

Assemble handle

1-2

Attach upper handle

Remove clean solution tank (upper tank) from deep cleaner.

1-5

B

1-3

A

With cord hook (A) to back of deep cleaner, push upper handle down onto lower han- dle. Push b o l t s into holes on f ront of han- d l e. If bolts will not go through hole easi- ly handle is not pushed completely down.

1-6

Place nuts in recessed areas on back of handle. Hold each nut in place while tightening each bolt securely with a Phillips screw driver.

Only two nuts are needed on this model. The extra nut is not required but has been provided for your convenience.

1-7

Press cord into cord clip on back of handle. Pull cord tight.

When handle sections are completely together, squeeze trigger (B) on upper handle to snap trigger rod In place.

1-8

Attach hose clip

Push tab on side of clip into hole on side of handle.

Replace clean solution tank (upper tank) by positioning bottom first. Press on tank handle to snap top of tank into place.

1-9

Pivot clip and push other tab into hole at back of handle to lock into place.

4