E
The deep cleaner may also be lifted by placing a hand under the upper clean solution tank handle as shown.
Automatic “shut off”
When the recovery tank (lower tank) is full the automatic shutoff mechanism will shut off the deep cleaner suction (suction will be noticeably reduced).
At that time the red float disk will rise to the top of the recovery tank lid (E). The deep cleaner will no longer pick up dirty solution and the motor sound will become noticeably higher in pitch.
When this happens turn deep cleaner off and empty recovery tank before
continuing use.
Check clean solution tank also; it may need to be refilled.
Brush speed selector
Your ‘SteamVac’ deep cleaner has three agitator brush settings.
Hl - for normal cleaning of carpet and bare floors
LO - for gentle cleaning of carpets and bare floors
OFF - for cleaning carpets and bare floors when brushing is not desired. (Such as when picking up liquid spills. See page 10.)
Slide selector button to the desired set- ting before cleaning.
F
G
Brush indicator
The brush indicator will spin (F) when the deep cleaner is turned ON and the brushes are rotating.
If the indicator does not spin and the pattern is visible (G) when the deep cleaner is turned ON, the brushes are not rotating.
There are three reasons why the brushes may not be rotating:
1.Brush speed selector set on OFF (see previous section).
2.Handle in upright position (see “CIeaning mode indicator,” Fig.
3.Brush indicator screen dirty.
H 
To clean screen (H), turn deep cleaner off and disconnect from electrical outlet.
Remove clear cover and wipe off screen with a damp cloth. Snap cover back into position.
The tanks
Clean solution tank
(upper tank)
The clean solution tank holds the clean- ing solution that is to be dispersed onto the surface to be cleaned.
How to fill
Disconnect deep cleaner from electrical outlet.
Place deep cleaner handle in the upright, locked position.
To remove tank, press down on handle and pull forward.
Carry tank to a sink.
Continued ➜
7