Lubrication
The motor is equipped with bearings, which have been lubricated for the life of the motor. The addition of lubricant could cause damage. Therefore, do not add lubricant to either motor bearing.
The agitator is equipped with two ball bearings that should be lubricated periodically by a Hoover Factory Service Center or an Authorized Warranty Service Dealer.
If you have a problem
This appliance was inspected thoroughly and was in good operating condition when it was shipped from the factory. If a minor problem occurs, it usually can be solved quite easily when the cause is found. Therefore, this check list is provided to assist you.
Problem | Possible cause |
| Possible solution | |
A Cleaner | 1. Not firmly plugged in. | 1. Plug unit in firmly. | ||
won? run | 2. No voltage in wail plug. | 2. | Check fuse or breaker. | |
|
| 3. Blown fuse/tripped breaker. | 3. | Replace fuse/reset |
|
|
|
| breaker. |
|
|
|
| |
8. Cleaner | 1. Bag full. | 1. Change paper bag. | ||
suction | 2 Obstruction in hose, | 2. | Remove foreign object. | |
low | wands, or nozzle connector. | 3. | Clean filter. | |
|
| 3. Secondary filter dirty. | ||
|
| 4 Bag not opening. | 4. kg; bag by Winci | |
|
|
|
| . |
|
| 5. Suction regulator control | 5. | Adjust suction regulator. |
|
| improperly set. | 6. | Reconnect hose. |
|
| 6. Hose not property con- | ||
|
| netted to cleaner. |
|
|
| C. Agitator | 1. Hose power cord not | 1. Plug firmiy into receptacle | |
won’t run | firmly plugged in. |
| on cleaner base and | |
|
|
|
| underneath hand grip. |
|
| 2 Broken or worn betL | 2. Replace bett | |
|
| 3. Nozzle sealed to carpet | 3. | Open suction regulator. |
|
|
|
| |
| D. Nozzle | 1. Low cleaner suction. | 1. SeeitemB. | |
won’t | 2 Obstruction in nozzle | 2. | Remove foreign object. | |
| pick up | connector. | 3. see item c. | |
|
| 3. Agitator not running. | ||
|
| 4. Agitator brushes worn. | 4. Replace brushes. | |
|
|
|
|
|
17