Hoover SteamVac V2 manual Storing hose and tools, SpinScrub hand tool

1-9

H

G

Rotate top of caddy toward cleaner handle. Slide caddy down so notch (G) on caddy rests in hook (H) on cleaner.

1-10	I
	J

Identify the hose parts before storing hose.

I. Nozzle connector end J. Solution tube

1-11

I

Storing hose and tools

Press hose, a few inches from nozzle connector end (I), into caddy. Bring hose up and over top of caddy.

1-12

K

Press hose into opposite side of caddy. Loop hose at bottom of cleaner and press into top of hook (K).

1-13

M

L

Loop hose over top of caddy again. Slide hose clip (L) toward end of hose.

Snap tab (M) on hose connector into hose clip.

1-14

J

Repeat on other end of hose.

Press solution tube (J) into opposite side of clip.

1-15

Insert top of bare floor tool (available at additional cost if not included with your cleaner) through “loop” on caddy. Slide tool down into place.

1-16 1-17

Snap stair/upholstery nozzle onto	SpinScrub™ hand tool
caddy.	(not included with all models)

The SpinScrub™ hand tool is shipped in a plastic bag for protection. To remove the bag before using the tool, open tool door.

5