How to use
Power nozzle
The power nozzle adjusts automatically for cleaning hard surface floors and various heights of carpet. The agitator may be turned off by unplugging power nozzle cord from hand grip when cleaning irregular floor sutfaces such as brick, slate, and certain parquet floors. This will stop the agitator from rotating. If desired, a special Wall/Floor Brush (shown in Cleaning Tools section) can be purchased for this task.
Handle positions
The handle has two positions when used with the power nozzle: upright and operating.
To lower handle to operating position, place your foot on the power nozzle and push handle down.
Edge cleaning
Brushed edge cleaning is provided on the right side of the nozzle to remove imbedded dirt in carpet near baseboards and furniture.
Standard edge cleaning is provided on the left side of the nozzle to remove surface dust and litter.
Guide right or left side of nozzle along edge of carpet for type of edge cleaning desired.
Suction regulator
The suction regulator is located on the hand grip and may be used to increase or decrease suction for various cleaning tasks.
If power nozzle is difficult to push on some carpet, open suction regulator. This will prevent damage to the belt.
7