Hoover 56518114 manual Assemblehandle Attach upper handle, +thhose hook A1 and cord hook A2 to

The assembled cleaner wi+l took like this

drawing (LS modet shown),

Assemblehandle

m

AI

A2

i

Attach upper handle

Remove clean solution tank (upper tank)

from de_;p clc-an_;r,

W+thhose hook (A1) and cord hook (A2) to

back of deep cleaner, push upper handle

down onto lower handle, Push bOllS into

ho+s on front of handle. If bolts will not go through hole easily handle is not

pushed completely down,

)/

/

Attach hose holder

Position hose holder (B) onto handle by

matching tabs on rack with op[_nings on

back of handle, Make sure holes for

bolts are aligned,

Replace	clean	solution	tank	(upper	tank)
by positioning		bottom	first,	Press	on

tank handle to snap top of tank into

place.

4

Place	nuts	in	recessed		areas		on		back of
handle,		Hold	each	nut	in	place		while
tightening		each	bolt	securely			(from		the
front	of the brindle)			with	a	Phillips			screw
driver,
Only	two	nuts	are	needed		on	this		model,
The	extra	nut	is not	required			but		has
beelq	provide_		for	your	convenience,

Attach tool holder

Remove tool and taped screw from holder.

Insert projections on holder into slots on

b_k of cleaner,

When handle sections are completely together, squeeze trigger (C) and depress Clean Surge TM Button* (D) on upper handle.

You will hear a "snap"when the trig- ger rod is in place.

+some models

Slide	rack	down	into	place,	insert	screw
at (E)	and	tight_;n	with	a Phillips		screw-
driver,