Electrolux Z430 Series manual Problem Solving, Remove a Clog in the Base

PROBLEM SOLVING

Remove a Clog in the Base

This model has a clean-out port which allows access into the bottom of the power nozzle in order to remove large debris that has become lodged in the airway.

CAUTION: Turn off the power switch and unplug the electrical cord to service.

1.On the bottom of the power nozzle, locate the transparent Clean-Out Port Door located between the wheels. (See page 4)

2.Remove the port door by squeezing the latch at the back of the nozzle and rotating the port door forward. No tools are needed for this step.

3.Locate and remove clog from the power nozzle. If needed, you may remove the power nozzle from the main body of the cleaner to locate the clog in the neck of the power nozzle.

4.Reattach the clean-out port door by inserting the front edge into position and rotating the door into the base until the latch snaps into place. Ensure that the latch is secure. Do not use the vacuum without first reattaching the clean-out port door.

Automatic Brushroll Circuit Protector

This vacuum comes equipped with a brushroll circuit protector which turns the brushroll off in the event of a stall situation. A locked brushroll condition is indicated with the signal light on the hood.

CAUTION: Turn off the power switch and unplug the electrical cord to service.

1.Turn off the vacuum and unplug it.

2.Remove the obstruction from the brushroll.

3.Plug the cleaner back in and turn the vacuum on to continue cleaning.

4.Periodically remove hair and threads from the brushroll.

Clean-Out

Port

Brushroll

Clean-Out

Port (Open)

PROBLEM SOLVING